XciteRC 15001310 Instruções de Operação descarregar pdf (Página 27)

XciteRC Rocket 400 GPS

Maintenance · Trouble shooting

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good

condition and to minimize wear.

• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a

harder brush or a toothbrush can be used.

• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up

liquid.

• Check the tightness of all screws and tighten if necessary.

• Also check all connections, cables and power battery / rechargeable battery for damage.

•

WARNING: Damaged batteries or rechargeable batteries must not be used again and must be

disposed of immediately – ﬁre hazard! Please note the disposal notes at the end of this manual.

• Check the model for worn, broken or jammed parts and gears and repair if necessary.

•

WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in

use – ﬁre hazard!

Troubleshooting

Problem Solution

Model ﬂies circles in Hold

mode

GPS signal poor, look for another place and try again

GPS signal poor, ﬂy. 3-5 minutes in normal mode and check the green

GPS-LED. If it is still on check Position Hold once more

Motors won’t start Switch SWA not in position 0

Battery voltage low, recharge or exchange battery

Model doesn’t take off Check the assembly of the propellers – rotational direction

Modell lands in Coming Home

mode far away from the star-

ting position

GPS signal poor, look for another place and try again

Model has no stable hover

ﬂight

Re-calibrate model (see paragraph Operation, point 7)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Sem comentários

XciteRC 15001310 Instruções de Operação Página 27